We have Front
axles and Spindles for the older Fast Track cars.
Check and make sure which axle your car has.
The top axle is the newer F/T axle with the shock mount
on the outside of the radius arms. There are two positions for the
shock to mount - one is right below the axle the other is 2"
down. This axle uses the curved arm spindles. For coil cars
only.
The bottom axle is the original F/T Swept Axle -
26 1/2" - spindle to spindle - for torsion bars.
It uses the spindles with the straight arms.
The Swept Axle is also available as a 10 degree axle with 10
degree spindles for dirt.
NOT SHOWN -- The next step up from the Standard Swept Axle is the Offset Axle with torsion bar
tabs. The shock mount is on the inside of the radius arms. This axle
uses the spindles with the curved arms for Zero Scrub.
Bumpers
& Knerfs
We can make these for the
older Fast Track cars
Specify
height and width on Bumpers
Chrome or
unchromed
Pointed rear
Bumpers
Square rear
Bumpers
4 Point Knerfs,
short or long
NOTE
A 14" Bumper
fits a 14" frame, measured Outside to Outside
A 15" Bumper
fits a 15" frame, measured Outside to Outside
To confirm that we are
sending you the right bumper, please measure your bumper in both
directions, across and up & down. You can give us the
center-center dimensions or you can give us the outside - outside
dimensions - just tell us which they are.
List these dimensions in the comments section of the invoice
form.
